Page 1 of 1

A301 Help and setup software

Posted: Sun Jul 19, 2020 2:42 am
by McgLance
Hi,

Bought the A30T, have it built and printing the the file on the micro sd it came with and seems to be going just fine,

however I am finding it amazingly hard to find all the info I need to setup either Cure, Slic3r .. Is there any that come with the A30T as a defined printer in it?

Just seems messy around the site and forums to get a default setup working and ready to go.. should be a package.. download this software, import this like this, presto your ready to 3d print...

Re: A301 Help and setup software

Posted: Thu Aug 13, 2020 5:52 pm
by lion
If cura and Slic3r are not easy to set up, maybe you can try the Repetier-host. This software has an introduction video.
https://www.youtube.com/watch?v=_limgP8 ... pL0zNWG7ne
You can also download the cura configuration file on the official website.
https://www.geeetech.com/download.html?download_id=47