A301 Help and setup software

Post Reply
Posts: 8
Joined: Mon May 04, 2020 8:00 pm

A301 Help and setup software

Post by McgLance » Sun Jul 19, 2020 2:42 am


Bought the A30T, have it built and printing the the file on the micro sd it came with and seems to be going just fine,

however I am finding it amazingly hard to find all the info I need to setup either Cure, Slic3r .. Is there any that come with the A30T as a defined printer in it?

Just seems messy around the site and forums to get a default setup working and ready to go.. should be a package.. download this software, import this like this, presto your ready to 3d print...

Posts: 13
Joined: Fri Aug 07, 2020 3:06 pm

Re: A301 Help and setup software

Post by lion » Thu Aug 13, 2020 5:52 pm

If cura and Slic3r are not easy to set up, maybe you can try the Repetier-host. This software has an introduction video.
https://www.youtube.com/watch?v=_limgP8 ... pL0zNWG7ne
You can also download the cura configuration file on the official website.

Post Reply