Extruder Extension Board from Geeetech
-
- Posts: 2
- Joined: Sat Mar 30, 2019 5:14 am
Extruder Extension Board from Geeetech
Hi, is there anything to change from the wires when i connect a new extruder Extension Board to my A30? on the original board all temperatures are ok but on the new from geeetech the hotend shows minus degrees and fans don't turn
- Attachments
-
- ext-board.JPG (58.42 KiB) Viewed 16606 times
Re: Extruder Extension Board from Geeetech
Hi, You can check if your hot end thermistor is fully connected.
Check your fan connection location.
Check your fan connection location.
-Keep your mind and try to test it.
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-
- Posts: 2
- Joined: Sat Mar 30, 2019 5:14 am
Re: Extruder Extension Board from Geeetech
I checked yesterday all connection 2times but i have only 15volts output on the connector for proximity switch(i think the new board is 12v), on the old(original board) the output is 24volts on the same pins. my A30 is a 24volts version but i have not seen anything on the website with 12v version and 24v version.
in the first step i thought the board is defect but i ordered 2 and on both is the same. so i went back now to the original and think the boards are for the trash can.
in the first step i thought the board is defect but i ordered 2 and on both is the same. so i went back now to the original and think the boards are for the trash can.
Re: Extruder Extension Board from Geeetech
Hi, You can refer to this to connect:
-Keep your mind and try to test it.
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Re: Extruder Extension Board from Geeetech
Aren't the capacitive sensor and 3d touch sensor connections reversed in this description? The 3d touch sensor has 5 wires and the capacitive sensor only has 3 wires.
Last edited by jm1 on Sat May 16, 2020 10:09 pm, edited 1 time in total.
Re: Extruder Extension Board from Geeetech
Hi,there is no problem connecting as shown.
-Keep your mind and try to test it.
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-
- Posts: 9
- Joined: Thu May 21, 2020 9:02 pm
Re: Extruder Extension Board from Geeetech
William, jm1 seem to be right, the BLTouch/3DTouch needs 5 wires and I recently connected one to the connector with 5 pins with success - it is not possible to connect 3DTouch to 3-pin connector.