table does not stick

Post Reply
Jacson122
Posts: 0
Joined: Tue Apr 17, 2018 2:41 am

table does not stick

Post by Jacson122 » Sun Apr 22, 2018 12:43 pm

ABS / PLA does not stick to the table, I do not know what to do.
Do I have to put glue or something?
Or some setting that are not correct?
My printer is an A30.

User avatar
_kaktus_
Site Admin
Posts: 1260
Joined: Fri Dec 15, 2017 10:06 pm
Location: PL
Contact:

Re: table does not stick

Post by _kaktus_ » Mon Apr 23, 2018 10:08 pm

The work table (hot bed) must be clean and properly warmed up.
You can buy something similar:
https://www.ebay.com/itm/3D-Printing-Bu ... 8183943?ss

I use something that nobody has come up with here ;-)

[attachment=0]lakier_do_wlosow.jpg[/attachment]

The cost is small, the effectiveness of good, smells good, it is easy to wash off with clean water. ;-D
Attachments
lakier_do_wlosow.jpg
hair spray
lakier_do_wlosow.jpg (299.75 KiB) Viewed 6440 times

slash24nl
Posts: 0
Joined: Mon Apr 23, 2018 10:30 pm

Re: table does not stick

Post by slash24nl » Mon Apr 23, 2018 10:35 pm

Have you leveled your printbed correctly?
It's really important to do an manual leveling procedure, fit a standard A4 paper between the nozzle and the bed.

Also, what temperature is your bed during print? And what nozzle temp do you use?
There are many possible reasons for a print not sticking to the bed.

Post Reply