Greetings,
I seem to be having some trouble with my prints and was wondering if anyone else on here has had the same issue.
It will print about 30-40-ish layers fine, but then start catching and botching the print. My assumption is that it has to do with the z-axis motor mounts as the motor on the extruder side likes to wobble.
Is this a common issue with the A30 and is there a fix for it?
Any help given would be greatly appreciated.
Print Quality Troubleshooting
-
- Posts: 1
- Joined: Wed Sep 26, 2018 4:06 am
Print Quality Troubleshooting
- Attachments
-
- 15379061074852637051203104551962.jpg (279.95 KiB) Viewed 3769 times
-
- Posts: 11
- Joined: Sat Oct 06, 2018 2:27 am
Re: Print Quality Troubleshooting
Looks like the z is not lifting, it does that if the cross bar is not parallel to the bed. Can you hear a gringing noise, or hold your hands on the vertical bits and feel if it vibrates.
Use a vernier (or tape measure if you not got a vernier) and make sure its perfectly level (you should level your bed manually first).
Use a vernier (or tape measure if you not got a vernier) and make sure its perfectly level (you should level your bed manually first).