A30M Nozzle & hot end ooze during print

Post Reply
Kburnsz1016
Posts: 4
Joined: Wed Dec 09, 2020 6:15 am

A30M Nozzle & hot end ooze during print

Post by Kburnsz1016 » Mon Aug 29, 2022 6:03 am

I was having an issue with filament oozing from the nozzle base (not the tip where filament comes out). I tried replacing the nozzle but it would not tighten. Figuring the threads were stripped on the hot end I replaced the entire extruder. During the first print with brand new hot end and new nozzle I am getting the same type of oozing from the nozzle base. Any suggestions?
Top
Post Reply

Return to “Geeetech A30 Series”