Anyone want to share their Slic3r Profile?

[Sneakers]

I was wondering if anyone would like to Share their print settings for Slic3r? I've recently switched to Slic3r from Cura and am curious to see what settings others are printing with.

Thanks!

[Lexan]

u might take a look in the facebook group, the profiles of AkosW are almost perfekt to start with

[Sneakers]

Thanks, but I'm not on Facebook. Any chance you could post it here?

[Lexan]

https://www.dropbox.com/s/ekt2i9k5ulh8z ... W.ini?dl=0

[Sneakers]

Thank you so much!!!

[advil]

Another BIG Thank You for posting that profile link!

Many of us will not touch Facebook and this Slic3r profile is quite good just as it is.

I got a good first print benchie out of it, and the only change I made after that was increasing retract from 6.5mm to 7.5mm and the second benchie was nearly perfect for a .2mm layer print.

[Lexan]

you're welcome

[Gr1f1S]

Hello ,
this profile is also goold for the geeetech A20 ?
Thanks