E180 priting bed is shaking

Post Reply
avale
Posts: 4
Joined: Wed May 27, 2020 4:17 pm

E180 priting bed is shaking

Post by avale » Wed May 27, 2020 4:28 pm

Hi All!

It's my first post here :-) I'm new with Geeetech E180, but with some experience with other 3d printers.

After a first trial (Belem Tower, located in Lisbon - Portugal), I noticed that the printer bed shakes a lot. I decided to unplug the bed and I noticed that there is a conveyor belt (obvious) that I can adjust, attached to a Bosch aluminium profile suported by 4 bearings. And the aluminium profile shakes between the bearings (these bearing are covered by rubber).

Any one noticed this??

Thanks!
Attachments
20200525_082602.jpg
20200525_082602.jpg (69.67 KiB) Viewed 9348 times

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: E180 priting bed is shaking

Post by William » Thu May 28, 2020 9:35 am

Hello, can you provide video? Here you can upload compressed files.
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

avale
Posts: 4
Joined: Wed May 27, 2020 4:17 pm

Re: E180 priting bed is shaking

Post by avale » Wed Jan 13, 2021 6:01 pm

Sorry for my delay, but when I decided to print again the Belem tower, the printing returned an error. Please see my other topic. Thanks!

Post Reply