Hi All!
It's my first post here I'm new with Geeetech E180, but with some experience with other 3d printers.
After a first trial (Belem Tower, located in Lisbon - Portugal), I noticed that the printer bed shakes a lot. I decided to unplug the bed and I noticed that there is a conveyor belt (obvious) that I can adjust, attached to a Bosch aluminium profile suported by 4 bearings. And the aluminium profile shakes between the bearings (these bearing are covered by rubber).
Any one noticed this??
Thanks!
E180 priting bed is shaking
E180 priting bed is shaking
- Attachments
-
- 20200525_082602.jpg (69.67 KiB) Viewed 9430 times
Re: E180 priting bed is shaking
Hello, can you provide video? Here you can upload compressed files.
-Keep your mind and try to test it.
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
Re: E180 priting bed is shaking
Sorry for my delay, but when I decided to print again the Belem tower, the printing returned an error. Please see my other topic. Thanks!