E180 Belt tensioning
-
- Posts: 5
- Joined: Sat Aug 05, 2017 11:01 pm
E180 Belt tensioning
Is there anyway to adjust the tension on the x axis without total dismantling the printer?
Re: E180 Belt tensioning
Hi GeeetechUK
Here are some steps to adjust the tension on the x axis
Sorry, the X-axis needs to be disassembled to adjust the belt
1.Remove the motor cable and screws 2.Remove the Teflon tube and extruder cable 3.Refer the pic and remove the screws
4. 5.Remove the belt carefully 6.Clean the glue carefully 7.Then you can remove it off and you can adjust it
Here are some steps to adjust the tension on the x axis
Sorry, the X-axis needs to be disassembled to adjust the belt
1.Remove the motor cable and screws 2.Remove the Teflon tube and extruder cable 3.Refer the pic and remove the screws
4. 5.Remove the belt carefully 6.Clean the glue carefully 7.Then you can remove it off and you can adjust it
-Keep your mind and try to test it.
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!
-
- Posts: 5
- Joined: Sat Aug 05, 2017 11:01 pm
Re: E180 Belt tensioning
Hi
I get to not but cannot get the cover off. Ant tips?
I get to not but cannot get the cover off. Ant tips?
-
- Posts: 5
- Joined: Sat Aug 05, 2017 11:01 pm
Re: E180 Belt tensioning
Fixed
Thanks for the help
Thanks for the help