Power Supply Problem with Prusa I3 Pro W

Post Reply
JRichi
Posts: 7
Joined: Wed Apr 01, 2020 4:45 pm

Power Supply Problem with Prusa I3 Pro W

Post by JRichi » Fri Apr 17, 2020 2:09 am

I printed three pieces a day without any problems. Then I turned off the printer.
The next day I turned on the printer ... but nothing happened. Printer is dead. When I connect it to the PC via USB, the display turns on, but the motors are not powered.
A quick check showed that the power supply was interrupted.

What can I do or how do I get a new power supply?

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: Power Supply Problem with Prusa I3 Pro W

Post by William » Fri Apr 17, 2020 11:39 am

Hi,you can check as follows:
1. First, check the connection of the motor to see if it is connected incorrectly.

2. If the connection is correct, you can swap the motor driver or motherboard interface to see if they are dead.

3. If the connection is correct, you can swap the motor wire to see if it is dead.

3. If the connection is correct, replace the motor with another axis motor. If the motor still cannot rotate, the motor is dead.

Hope can help you
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Post Reply