A30T BUG LIST

Post Reply
gio@dkonline.be
Posts: 42
Joined: Sun Apr 12, 2020 8:01 pm

A30T BUG LIST

Post by gio@dkonline.be » Tue Apr 28, 2020 8:57 pm

3D touch dont work, dont give 2X same value (tested with3 different 3D touch), Proxy sensor Work

Fan for fanduct too weak.

printer make many many many noise, need TMC drivers and replace 8010 fan case by a silent system.

Mix menu is not translated.

after reset software, all axis inverted and pid value replaced by bad value, need firmware update urgent.

need a good profil for cura, and other, too many stringing with mix extruder....

printer has good potential but still needs a lot of adjustment.

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: A30T BUG LIST

Post by William » Mon May 04, 2020 3:40 pm

Thanks for your feedback, we will improve as soon as possible.
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

gio@dkonline.be
Posts: 42
Joined: Sun Apr 12, 2020 8:01 pm

Re: A30T BUG LIST

Post by gio@dkonline.be » Tue May 05, 2020 8:37 am

NO PROBLEM

i have found a hardware problem on mainboard....

check with conceptor to reinforce line of fanduct fan, the thyristor dead by itself, same for other user of A30T.

after component replaced, fan ok

ans Y motor is to low, need to replace by a bigger,he loose step at 60mm/sec, i do try with a close loop this week

Post Reply