Geeetech

Thanks for all your tips ! Still remaining one issue in my case.
In the wiki, it is mentionned :

"From the display go to Menu and then Prepare/Move Axis/0.1mm/Move Z"
"Now move the Z axis slowly down..."

but I can only move it up in this case, either using Repetier.

Do I also need to tweak some other files in the firmware ?

--> Ok modified this to allow movement over the HOMEPOS:

My setting have no function.
//#define Z_PROBE_OFFSET_FROM_EXTRUDER -3.24 in the config.h
M 851says Echo:Z Offset -3.24

but the nozzle is to far from the bed. the distance does not change after modify the config.h

DoubleK wrote: ↑

Wed Aug 02, 2017 3:36 am

My setting have no function.
//#define Z_PROBE_OFFSET_FROM_EXTRUDER -3.24 in the config.h
M 851says Echo:Z Offset -3.24

but the nozzle is to far from the bed. the distance does not change after modify the config.h

I have the same problem, is it possible that nobody has the solution?

Hi, When you adjust the z offset
Need modifications to you,
Save it.
You can refer to this specifically: viewtopic.php?f=27&t=18371