Something you need to know before using 3D Touch

NicoFR
Posts: 6
Joined: Sun Dec 18, 2016 12:59 am

Re: Something you need to know before using 3D Touch

Post by NicoFR » Sat Mar 04, 2017 11:07 pm

Thanks for all your tips ! Still remaining one issue in my case.
In the wiki, it is mentionned :

"From the display go to Menu and then Prepare/Move Axis/0.1mm/Move Z"
"Now move the Z axis slowly down..."

but I can only move it up in this case, either using Repetier.

Do I also need to tweak some other files in the firmware ?

--> Ok modified this to allow movement over the HOMEPOS:

Code: Select all

#define min_software_endstops false

DoubleK
Posts: 15
Joined: Fri Dec 09, 2016 5:39 am

Re: Something you need to know before using 3D Touch

Post by DoubleK » Wed Aug 02, 2017 3:36 am

My setting have no function.
//#define Z_PROBE_OFFSET_FROM_EXTRUDER -3.24 in the config.h
M 851says Echo:Z Offset -3.24

but the nozzle is to far from the bed. the distance does not change after modify the config.h

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest