Page 1 of 1
Auto bed leveling for Prusa I3 with Sanguinololu & LCD2004
Posted: Fri Apr 24, 2015 7:18 pm
by vad7
Board: Sanguinololu 1.3a & LCD 2004 smart controller with SD card.
Firmware: Marlin 1.0.3
Servo: Super-Micro Waypoint W-038CL
Used control pin for servo: A1 (#30).
Need to change the adapter board for LCD: cut track near A1 pin, connect A1 pin to A0 pin.
SD card works fine.
http://www.thingiverse.com/thing:790758
Re: Auto bed leveling for Prusa I3 with Sanguinololu & LCD20
Posted: Thu May 21, 2015 7:52 am
by orest
I am interested in doing this with either a capacitive or inductive probe. I have the i3b pro printer with a Sanguinololu board. The idea is to replace the the z end stop with one of these probes. Does anyone have an idea as to what the wiring should be. There are 3 wires, 2 for power and one for signal.
Re: Auto bed leveling for Prusa I3 with Sanguinololu & LCD20
Posted: Fri May 22, 2015 12:22 am
by 4x6hp
Do need some modifications in the firmware, for auto bed leveling work?
Re: Auto bed leveling for Prusa I3 with Sanguinololu & LCD20
Posted: Sat Aug 20, 2016 8:10 pm
by Gerard123
Re: Auto bed leveling for Prusa I3 with Sanguinololu & LCD20
Posted: Thu Oct 06, 2016 6:11 am
by Martindb
Do you think I can use A1for soft pwm fan control with this mod?
Re: Auto bed leveling for Prusa I3 with Sanguinololu & LCD20
Posted: Wed Feb 15, 2017 10:22 pm
by amerrigan
Would the same mod work for BL/3Dtouch probes?