Auto bed leveling for Prusa I3 with Sanguinololu & LCD2004

Post Reply
vad7
Posts: 28
Joined: Sun Mar 29, 2015 1:08 pm

Auto bed leveling for Prusa I3 with Sanguinololu & LCD2004

Post by vad7 » Fri Apr 24, 2015 7:18 pm

Board: Sanguinololu 1.3a & LCD 2004 smart controller with SD card.
Firmware: Marlin 1.0.3
Servo: Super-Micro Waypoint W-038CL
Used control pin for servo: A1 (#30).

Need to change the adapter board for LCD: cut track near A1 pin, connect A1 pin to A0 pin.
SD card works fine.

http://www.thingiverse.com/thing:790758

orest
Posts: 18
Joined: Fri Apr 03, 2015 2:55 pm

Re: Auto bed leveling for Prusa I3 with Sanguinololu & LCD20

Post by orest » Thu May 21, 2015 7:52 am

I am interested in doing this with either a capacitive or inductive probe. I have the i3b pro printer with a Sanguinololu board. The idea is to replace the the z end stop with one of these probes. Does anyone have an idea as to what the wiring should be. There are 3 wires, 2 for power and one for signal.

4x6hp
Posts: 9
Joined: Fri May 15, 2015 8:14 pm

Re: Auto bed leveling for Prusa I3 with Sanguinololu & LCD20

Post by 4x6hp » Fri May 22, 2015 12:22 am

Do need some modifications in the firmware, for auto bed leveling work?

Gerard123
Posts: 7
Joined: Fri Aug 19, 2016 2:57 am

Re: Auto bed leveling for Prusa I3 with Sanguinololu & LCD20

Post by Gerard123 » Sat Aug 20, 2016 8:10 pm

You're looking, as example, for this one ?

http://www.instructables.com/id/Enable- ... Marlin-Fi/

Martindb
Posts: 1
Joined: Thu Sep 15, 2016 5:44 am

Re: Auto bed leveling for Prusa I3 with Sanguinololu & LCD20

Post by Martindb » Thu Oct 06, 2016 6:11 am

Do you think I can use A1for soft pwm fan control with this mod?

amerrigan
Posts: 4
Joined: Sat Jan 07, 2017 7:03 am

Re: Auto bed leveling for Prusa I3 with Sanguinololu & LCD20

Post by amerrigan » Wed Feb 15, 2017 10:22 pm

Would the same mod work for BL/3Dtouch probes?
Image

Post Reply