Printed model skewed

Post Reply
entretoize
Posts: 9
Joined: Wed Feb 06, 2019 9:18 pm

Printed model skewed

Post by entretoize » Wed Feb 06, 2019 9:42 pm

Hello, I'm printing abs models with the A10 and I found good settings for the print quality, however, my prints are skewed in the Y axis.
I don't see how it is possible, if it was the motor that loose step it would be random but here it is very linear.
I leveled the corners the best I can and I think it can't be the plate that is not horizontal.
Finally as the printer uses geers, it can't be the belt that would slide.

So what is it ?
Can it be corrected programaticaly when generating the gcode or even in the printer settings ?

Thanks in advance
Attachments
skewed.png
skewed.png (217.56 KiB) Viewed 16960 times

gopher
Posts: 58
Joined: Tue May 05, 2020 9:41 pm

Re: Printed model skewed

Post by gopher » Fri Jul 10, 2020 1:04 pm

Hm... Try to mirror the model in slicer and try to print that.
And what about calibration cubes? Have you printed them?

Post Reply