Page 1 of 1

Print Slanted on the Y Axis

Posted: Sat Jan 13, 2018 2:15 am
by NightStorm1000
Hi!

I recently build my I3 Or and noticed something

My Prints come out slanted on the Y Axis

Any Idea?

Here is a Picture

https://www.dropbox.com/s/5zaqnype7wioa ... 5.jpg?dl=0

Re: Print Slanted on the Y Axis

Posted: Wed Jan 17, 2018 7:59 pm
by William
1.Check the belt of Y axis

2.Increase the voltage of Y-axis driver board A4988
ADJUST.png
ADJUST.png (206.02 KiB) Viewed 3795 times
3.Adjust the tight of Y-axis screw
Y motor.png
Y motor.png (839.18 KiB) Viewed 3795 times

Re: Print Slanted on the Y Axis

Posted: Wed Jan 24, 2018 5:05 am
by NightStorm1000
Adjusting Acceleration, Jerk and Steps fixed it.
Thanks anyway!