Page 1 of 1

Printing with PLA - your experience

Posted: Thu May 18, 2017 12:08 am
by Tiamet3D
Hi, everyone!

We're currently undertaking a small survey (won't even take a minute to fill out) on printing with PLA and we need you to participate. We'd like to know what your experience with PLA is, whether you use it or not. This way, we'd like to be able to cater to your 3D printing needs. It'd be awesome if you could help us by filling out the survey on the following link: https://docs.google.com/forms/d/e/1FAIp ... sp=sf_link
Thank you very much for your help!

Best regards,
Stani

Re: Printing with PLA - your experience

Posted: Wed Jan 03, 2018 5:01 am
by LadyQ
Do not buy FoxSmart pla . is erratic in extrusion. take too much heat to start and takes too much time to set fine tuning .