XY axis angle calibration?

Post Reply
tanakas
Posts: 6
Joined: Thu Jan 19, 2017 7:49 am

XY axis angle calibration?

Post by tanakas » Thu May 04, 2017 5:37 am

Hello,

I have a Geeetech i3 pro b, and the X and Y axes are not perpendicular.

I was not successful in correcting it mechanically, because the Geometry (basically parallelograms) is not very suitable for angle corrections.

Before I start drilling and sawing: how do you effectively calibrate the XY angle?

Also, I was not successful in finding software-based calibrations (like with the Original Prusa i3 mk2). Is there a possibility in Marlin?

User avatar
William
Site Admin
Posts: 3947
Joined: Tue Jun 07, 2016 9:38 am

Re: XY axis angle calibration?

Post by William » Fri May 12, 2017 4:50 pm

Hi,could you show some pictures or videos about the X,Y axis?It will more helpful for me to understand.
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

silviop
Posts: 0
Joined: Thu Mar 08, 2018 5:02 pm

Re: XY axis angle calibration?

Post by silviop » Thu Mar 08, 2018 5:10 pm

Same thing here , i buy i3 pro b and if i print square became parallelogram (about 1mm every 10cm).

there is no way to correct mechanically i think to print a front support with smooth rod holes shifted to compensate this angle.

bjoern
Posts: 0
Joined: Mon Mar 19, 2018 7:50 pm

Re: XY axis angle calibration?

Post by bjoern » Mon Mar 19, 2018 8:03 pm

Hi,

I have the same problem -> 2.5mm every 150mm ... I have no idea how to fix the problem on my hardware.
Yesterday I wrote a little java programm, that correct the y-values in my exported stl-files.

With this workarround I can get acceptable prints.

The programm determines the lowest x-value in the stl-file and calculate for every vertex in relation to the lowest x-value an y-offset.

If you need. I could provide the code.

best regard

bjoern

User avatar
_kaktus_
Site Admin
Posts: 1159
Joined: Fri Dec 15, 2017 10:06 pm
Location: PL
Contact:

Re: XY axis angle calibration?

Post by _kaktus_ » Wed Mar 21, 2018 12:32 am

Gentlemen, did any of you try to correct the number of steps for 1mm stepper motor?

After all, this is the basic calibration of the printer.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest