2 posts • Page 1 of 1
Hello my name is Rich and I'm new to printing. Just finished my printer build and started printing. My first print was a flop because I did not have the correct amount of infill but my second print turned out ok. I printed a file for a part that I received broke from geeetech. The print is very strong and usable so I am happy about that. I have a lot to learn about infill, layer height and so much more. Please look at printed piece and give me advice to make my next print better. I3 Pro c dual extruder. Oh by the way getting both nozzles level is a hard days work. I wish there was a good video showing an easier way. I watched a video that gave me the basic method buy doing it on the MK8 was a pain.
- IMG_0189.JPG (21.17 KiB) Viewed 1846 times
- IMG_0187.JPG (27.05 KiB) Viewed 1846 times
- IMG_0188.JPG (36.42 KiB) Viewed 1846 times
Who is online
Users browsing this forum: No registered users and 2 guests