Post Reply
Posts: 1
Joined: Sat Dec 24, 2016 3:42 am


Post by Rsswesley » Thu Jan 12, 2017 1:14 pm

Hello my name is Rich and I'm new to printing. Just finished my printer build and started printing. My first print was a flop because I did not have the correct amount of infill but my second print turned out ok. I printed a file for a part that I received broke from geeetech. The print is very strong and usable so I am happy about that. I have a lot to learn about infill, layer height and so much more. Please look at printed piece and give me advice to make my next print better. I3 Pro c dual extruder. Oh by the way getting both nozzles level is a hard days work. I wish there was a good video showing an easier way. I watched a video that gave me the basic method buy doing it on the MK8 was a pain.
IMG_0189.JPG (21.17 KiB) Viewed 1845 times
IMG_0187.JPG (27.05 KiB) Viewed 1845 times
IMG_0188.JPG (36.42 KiB) Viewed 1845 times

Posts: 402
Joined: Wed Dec 28, 2016 2:12 pm

Re: Excited

Post by bang » Fri Jan 13, 2017 6:32 pm

BTW,i think the descriptions are detailed enough about printing for a dual-head.

Post Reply

Who is online

Users browsing this forum: No registered users and 4 guests