Printed an ornament with my M301. Starting to get some decent prints but getting lots of strings as shown in the second photo. First photo shows a quick effort at removing some of the strings. Printed at 190 deg except for a little near the bottom at 200 and 210 which made the strings worse. 1 mm retraction was used which slowed the print considerably. Sliced with Slic3r; I may try Cura or look for settings that avoid crossing outside perimeters.
--Dave
- Ornament after cleanup.jpg (405.1 KiB) Viewed 4130 times
- Ornament before cleanup.jpg (486.6 KiB) Viewed 4144 times