Happy Holidays!

Post Reply
Veenoh
Posts: 54
Joined: Thu Dec 08, 2016 12:31 am

Happy Holidays!

Post by Veenoh » Sun Dec 25, 2016 10:44 pm

Merry Christmas and Happy Hanukkah to all!

Printed an ornament with my M301. Starting to get some decent prints but getting lots of strings as shown in the second photo. First photo shows a quick effort at removing some of the strings. Printed at 190 deg except for a little near the bottom at 200 and 210 which made the strings worse. 1 mm retraction was used which slowed the print considerably. Sliced with Slic3r; I may try Cura or look for settings that avoid crossing outside perimeters.

--Dave
Ornament after cleanup.jpg
Ornament after cleanup.jpg (405.1 KiB) Viewed 1382 times
Ornament before cleanup.jpg
Ornament before cleanup.jpg (486.6 KiB) Viewed 1396 times

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest