Page 1 of 1
Printing problem-who can help me?
Posted: Tue Oct 04, 2016 5:40 pm
by n.moschin
Hello everyone, I have a recurring problem on every print...
It seems a periodic disturbance to the mechanics but it's all ok.
I will upload a pic of the problem because it is difficult to describe the ridges that form.
Anyone have the same problem or know how to fix it?
Thanks
N.M.
Re: Printing problem-who can help me?
Posted: Wed Oct 05, 2016 10:00 am
by ggg666
n.moschin wrote:Hello everyone, I have a recurring problem on every print...
It seems a periodic disturbance to the mechanics but it's all ok.
I will upload a pic of the problem because it is difficult to describe the ridges that form.
Anyone have the same problem or know how to fix it?
Thanks
N.M.
Hi,
Looks like there is excessive extrusion or your Z axis has a abnormal movement.
You can refer to this article to make some troubleshooting:
https://www.simplify3d.com/support/prin ... eshooting/
Re: Printing problem-who can help me?
Posted: Wed Oct 12, 2016 11:37 pm
by n.moschin
Not solved yet.
I tried to setting mechanics but nothing changed.
Re: Printing problem-who can help me?
Posted: Sat Oct 15, 2016 4:13 pm
by William
You can decrease the value "extrusion multiplier" and check if your all your Z rods are straight.
And spread some lubricating oil on Z threaded rods.