Hi, I am hoping for some help with this issue.
My Y axis seems to have some vibration showing on my prints but only significantly in one direction. I removed the belt and the bed glides smoothly. I tried putting a twist in the belt but that didn't help. there just doesn't seem to be much resistance there.
I have included some photos if it helps.
These are the right side
[/img]
This is the side opposite (it has join marks)
[/img]
and these are the front and back
[/img]
Vibrating Y axis
Re: Vibrating Y axis
What's your printer model? The vibration may be because the belt is too loose, or there's something wrong with the wheel or the bearing?
Re: Vibrating Y axis
Incase anyone wants to know, that was the problem.
Took it right off and started again, needed a small trim and the tensioner on the x and y were set a bit wrong.
Prints are great now.
Thanks for your reply.
Took it right off and started again, needed a small trim and the tensioner on the x and y were set a bit wrong.
Prints are great now.
Thanks for your reply.