Me_Ducer calibrating Z-asis

[Mick]

Hello,

I bought Me_Ducer and I have a question - how I should calibrate Z-asis (bed's level relatively the nozzle)? Should I make it by the screws each time or I can make this in the RepeaterHost? Is it possible setup it in the Z-offset frame (EEPROM configuration)? May you recommend some right way?

Hope for your soon answer.

Thanks.

[Admin]

it is better to adjust the screw.
for this printer, you can refer to this videos.
https://www.youtube.com/playlist?list=P ... BgXLnqxpI4