Where have I gone wrong?

Post Reply
Neil PC
Posts: 6
Joined: Wed Feb 10, 2021 8:19 pm

Where have I gone wrong?

Post by Neil PC » Mon Mar 29, 2021 10:12 pm

Hi all
I have installed my first roll of filament and I cannot get a decent print
I have an A20T and bought some EONO filament from Amazon
I use cura slicer.
Attachments
20210329_142246.jpg
20210329_142246.jpg (341.53 KiB) Viewed 4048 times
20210329_142226.jpg
20210329_142226.jpg (291.62 KiB) Viewed 4048 times
20210329_142208.jpg
20210329_142208.jpg (220.52 KiB) Viewed 4048 times
20210329_142124.jpg
20210329_142124.jpg (298.36 KiB) Viewed 4048 times
Neil

User avatar
Admin
Posts: 486
Joined: Wed Nov 30, 2011 9:49 am

Re: Where have I gone wrong?

Post by Admin » Fri Apr 02, 2021 5:21 pm

Hello, you can try to print the object below. It may be a problem with your Cura settings, depending on the printing effect.
Attachments
cube.rar
(116.75 KiB) Downloaded 315 times

Neil PC
Posts: 6
Joined: Wed Feb 10, 2021 8:19 pm

Re: Where have I gone wrong?

Post by Neil PC » Mon Apr 12, 2021 7:32 pm

Thank you, I will give it a go.
I have persevered with it and got the quality as in the pictures, however i am now experiencing layer separation on the last 4 outer layers, but the rest of the print looks ok.

I apologise for the delay in coming back to you you ;)

I have just downloaded the Easyprint lite Beta from the downloads section to see if that makes a difference, but there is very little documents about changing setting. (i have watched the videos about colour mixing)

Neil
Attachments
20210406_102634.jpg
20210406_102634.jpg (20.82 KiB) Viewed 3806 times
20210406_102838.jpg
20210406_102838.jpg (20.73 KiB) Viewed 3806 times
Neil

Post Reply