Signals from USB Port via g.code
Posted: Wed Nov 18, 2020 3:47 am
Hello everyone,
I want to use the USB Port on my A20M to give out a high (5V) signal during a print. I'm trying to trigger a camera by using a g.code command to set the 'Pins' on the the USB Port of the printer to a high. Does anyone know if this is even possible? Is there an existing Pin-adresse (Pin-Number) for the USB Port which can be commanded via g.code?
Thanks in advance.
I want to use the USB Port on my A20M to give out a high (5V) signal during a print. I'm trying to trigger a camera by using a g.code command to set the 'Pins' on the the USB Port of the printer to a high. Does anyone know if this is even possible? Is there an existing Pin-adresse (Pin-Number) for the USB Port which can be commanded via g.code?
Thanks in advance.