A20M X motor oscillating
Posted: Fri Apr 05, 2019 5:29 pm
Hi
I'm new to the A20M and it worked fine, indeed very well, on the first layers of the dog. Then the x axis began to oscillate between +20 and +40mm. I t moves freely by hand without power, and all the wires, Internal and external seem fine. It still does this with when using the move controls in the menu, even after switching on off and resetting. Anybody else had this problem on a new machine?
I'm new to the A20M and it worked fine, indeed very well, on the first layers of the dog. Then the x axis began to oscillate between +20 and +40mm. I t moves freely by hand without power, and all the wires, Internal and external seem fine. It still does this with when using the move controls in the menu, even after switching on off and resetting. Anybody else had this problem on a new machine?
