x axis endstop - won't reach

Post Reply
walders
Posts: 1
Joined: Fri Feb 08, 2019 4:50 am

x axis endstop - won't reach

Post by walders » Sat Feb 09, 2019 9:37 pm

Hello,
I have an i3 Pro C. I've managed to get the axis to home in the right direction, but it crashes into the end of the board before it can reach teh endstop switch. Can anyone advise on how to correct this please?
There was a little blue acrylic 'stick' that I could attach to teh extruder frame, but this isn't long enough! I can't see anyhting else I'm missing.

THanks!

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests