Extruder motor

Post Reply
Repas97
Posts: 1
Joined: Fri Feb 17, 2017 2:44 pm

Extruder motor

Post by Repas97 » Fri Feb 17, 2017 3:00 pm

I think that I have a problem with system board. Problem is in the extruder step motor. The motor doesn't spin when is conected on extruder port (I checked the motor on other axels and it worked).
What do you think is problem?

bang
Posts: 402
Joined: Wed Dec 28, 2016 2:12 pm

Re: Extruder motor

Post by bang » Tue Feb 21, 2017 11:47 am

I'll ask the same question every time someone had the same issue as yours:
Did you heat your extruder before your test?
If you did,check the following post:
viewtopic.php?f=19&t=17097

Post Reply

Who is online

Users browsing this forum: No registered users and 21 guests