Prusa I3 M201 - Z axis is pulled down before printing

Mila
Posts: 12
Joined: Wed Feb 01, 2017 11:16 pm

Re: Prusa I3 M201 - Z axis is pulled down before printing

Post by Mila » Sat Feb 25, 2017 5:01 am

I don't get any erros, that's the problem, it transfers the firmware though the hyperlink terminal and the version stays the same.

The endstop works normally when homing the axis, the problem is only when I send the printing order, it homes (correctly, albeit a little higher) and then pulls the nozzle down, it will keep hitting the bed until I terminate it.

Mila
Posts: 12
Joined: Wed Feb 01, 2017 11:16 pm

Re: Prusa I3 M201 - Z axis is pulled down before printing

Post by Mila » Thu Mar 02, 2017 9:12 am

Is there any way I can get someone to look into that? I can't print with this printer as it is.

Post Reply