Page 4 of 4
Re: Mosfet problem
Posted: Mon Jun 22, 2015 9:02 am
by zhangxueyou
It looks terrible, please contact the customer service.
Re: Mosfet problem
Posted: Sun Jul 05, 2015 3:12 pm
by Pgioy
hello sorry if I send the message to you, but it's more than two weeks since I sent the e-mail where I have indicated, but even today I have not received any reply, you can help you. also because with the printer are stopped. thanks a lot
Re: Mosfet problem
Posted: Thu Dec 10, 2015 2:32 pm
by johnz
My just did the same thing...did you ever find out what was wrong???!!
Re: Mosfet problem
Posted: Thu Dec 10, 2015 3:58 pm
by Mark
hello, what's the problem with your board? see what I can do.
Re: Mosfet problem
Posted: Fri Dec 11, 2015 6:44 am
by johnz
The Heat bed stopped working and then I looked at the board and this is what it looks like and the heat bed reading in pic 2.
Re: Mosfet problem
Posted: Fri Dec 11, 2015 11:20 am
by Mark
seems your hotbed resistance is ok, how about check this link here:
http://www.geeetech.com/forum/viewtopic ... 13&t=17117
Re: Mosfet problem
Posted: Fri Dec 11, 2015 12:37 pm
by johnz
No the MOSFET is fried...Not working...check everything ...everything works except the hot bed!!! Just bought this in May 13, 2015 ....Cant believe it just fried like that,,,Damn!!
Re: Mosfet problem
Posted: Fri Dec 11, 2015 2:15 pm
by Mark
then you can replace the mosfet yourself or contact the sales directly to replace it.