Hi,
I Buy this printer: http://www.ebay.com/itm/JIETAI-Delta-Ro ... 4182bbdf69
I assemble and configure with Repetier Host. The radius of 99 mm and height of 400 mm .When pressed home all rises to endstops, but when sending XYZ to 0 the printer does nothing. To check, try print 10mm cube and starts printing from above, Z is the only that move down.
what I can do with this problem ???????????
Problems with new 3D Printer
Re: Problems with new 3D Printer
please makesure "printer settings">"printer shape">"printer type" is "Rostock printer" and "Home X,Home Y,Home Z" is MAX with Repetier Host.if you use slic3r ,Please amend the print center of 0, 0.