Page 1 of 1

Lcd problem when connected to ramps

Posted: Tue Nov 24, 2015 4:11 pm
by mava70
Hello I have had a gt2560 with 2004 lcd. Gt2560 is brocken so I swapped with a standard ramps/2560. Ai have to buy a standard lcd adapter on ebay for connecting 2004 to ramps. When I connect the lcd ribbon
Printer stop working and on pc I see a mintemp error reached. Lcd doesn't work but is correctly connected.
If I disconnect the lcd printer works normally.

Any idea?

Marco

Re: Lcd problem when connected to ramps

Posted: Tue Nov 24, 2015 5:10 pm
by Mark
which firmware are you using? you need to use the one for ramps board.

Re: Lcd problem when connected to ramps

Posted: Tue Nov 24, 2015 5:18 pm
by mava70
Yes the firmware is correct your firmware for rakps board prusa b and it works very well when lcd disconnected.
Lcd is correctly configured in config.h same as gt2560 firmware

Re: Lcd problem when connected to ramps

Posted: Wed Nov 25, 2015 5:24 am
by mava70
solved smart connector connectors are mounted reversed swapped cable now is ok