How to square gantry in A10,A20,etc

Post Reply
Liizok8u
Posts: 5
Joined: Tue Jan 21, 2020 10:49 pm

How to square gantry in A10,A20,etc

Post by Liizok8u » Wed Jan 22, 2020 2:52 am

Hey,

i allways wondered why even with perfect bed leveling, my prints didn't turn out great. With my square I noticed, that the hole gantry is tilted a quiet noticeably to the back. I tried to unscrew it (on the bottom) and straighten it. But when I tighten the screws, the gantry tilts backwards again.

I allready removed the spool and placed it in a holder next to the printer. I did not see any benefit in putting high weights on the top of the gantry.

Any tips on squaring it?

User avatar
William
Site Admin
Posts: 6340
Joined: Tue Jun 07, 2016 9:38 am

Re: How to square gantry in A10,A20,etc

Post by William » Wed Jan 22, 2020 9:51 am

:D Hi,You can check if your x-axis guide is normal,
Whether the upper and lower bearing wheels of the hot end are fastened.
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Post Reply