Missing Z-axis cable for Z-ES

Post Reply
leongy1717
Posts: 17
Joined: Tue Jun 11, 2019 6:12 pm

Missing Z-axis cable for Z-ES

Post by leongy1717 » Tue Jul 02, 2019 4:20 pm

During assembly and testing of new A10M printer, found missing Z-ES Cable per photos attached.

There is Z-M cable for Z-axis motor power, Y-ES Y-M and X-ES with X-M cable assemblies connected to respective stepper motor.

Is it dangerous to operate with Z-ES cable missing?

Please advise how and where on motherboard to make cable connect to Z-ES of stepper motor. Thanks.
Missing Z-ES Cable.JPG
Missing Z-ES Cable.JPG (47.33 KiB) Viewed 8813 times
Z-M Cable.JPG
Z-M Cable.JPG (54.06 KiB) Viewed 8813 times
LED Screen.JPG
LED Screen.JPG (110.5 KiB) Viewed 8813 times

User avatar
William
Site Admin
Posts: 5973
Joined: Tue Jun 07, 2016 9:38 am

Re: Missing Z-axis cable for Z-ES

Post by William » Tue Jul 02, 2019 4:37 pm

Hi, If you are missing the z-axis limit switch line, please contact your sales for a reissue, which will affect your printing. You can refer to this motherboard connection diagram:
v3板线连接位置.jpg
v3板线连接位置.jpg (296.1 KiB) Viewed 8811 times
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

leongy1717
Posts: 17
Joined: Tue Jun 11, 2019 6:12 pm

Re: Missing Z-axis cable for Z-ES

Post by leongy1717 » Tue Jul 02, 2019 5:37 pm

Am trying to raise hot bed up 10 mm on Z-axis but to no avail.

Is it advisable to trigger Z end-stop limit switch manually to do so?

Is fitting new BL - Touch to overcome/override Z end-stop possible? Thanks


P.S. --- Can also raise Z-axis 260 mm but not below 0 mm. Both X and Y no problem.

User avatar
William
Site Admin
Posts: 5973
Joined: Tue Jun 07, 2016 9:38 am

Re: Missing Z-axis cable for Z-ES

Post by William » Tue Jul 02, 2019 5:50 pm

Hi, I think you'd better contact your sales to reissue a z-axis limit switch line.
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Post Reply

Who is online

Users browsing this forum: No registered users and 6 guests