Page 1 of 1

I3 pro C: nozzle higher than extruder carriage after homing?

Posted: Wed Jan 13, 2016 3:48 pm
by Mark
Guys, if you have run into a problem that the nozzle is higher than the extruder carriage after homing, like this one below:
extruder.JPG
nozzle is higher than the extruder carriage after homing
extruder.JPG (251.96 KiB) Viewed 5054 times
Then don't worry, check the solution here:
Unscrew the upper nuts on extruder as the picture shows, and then lower down the two hotends to a proper height, and that's all.
But note that don't touch the nut on the heater block if not necessary, or it might leak!
extruder2.jpg
Unscrew the upper nuts, lower down the two hotends to a proper height
extruder2.jpg (88.81 KiB) Viewed 5051 times