Updated instructions for X carriage assembly in M201

Post Reply
Mark
Posts: 1553
Joined: Thu Aug 06, 2015 9:19 am

Updated instructions for X carriage assembly in M201

Post by Mark » Wed Dec 09, 2015 3:38 pm

If anyone bought the I3 M201, and find the nozzle is crashed to the bed far before the endstop is triggered:
1.jpg
1.jpg (811.51 KiB) Viewed 10160 times
Please come to 18. Assembly of the extruder carriage and assemble the X carriage like this:

Step1.fix the 4 Bearing Brackets on the back of the X Carriage loosely with M3x6mm screws. Insert the linear bearing into the slot and screw the bracket tightly.
2.jpg
2.jpg (226.55 KiB) Viewed 10160 times
3.jpg
3.jpg (235.37 KiB) Viewed 10160 times

Please notice the front and back of the plate.
The following steps differs from the video, please build based on this manual.


Step2.Fix the belt mount on the back of the carriage with 2 M3x 12mm screws and M3 hex nuts.
4.jpg
4.jpg (222.74 KiB) Viewed 10160 times

Step3. Fix the extruder holder on the front side of the X carriage using M4x6mm screws.
5.jpg
5.jpg (173.27 KiB) Viewed 10160 times
6.jpg
6.jpg (209.87 KiB) Viewed 10160 times
7.jpg
7.jpg (160.19 KiB) Viewed 10160 times
8.jpg
8.jpg (152.64 KiB) Viewed 10160 times
That's all.
Or you can contact the sales to get a new PDF instruction, thanks!

BJM
Posts: 2
Joined: Sat May 13, 2017 2:24 pm

Re: Updated instructions for X carriage assembly in M201

Post by BJM » Sun May 14, 2017 1:09 pm

interestingly my parts were not green or blue but black and after a little head scratching I managed to mount it so it works

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests