Adding Filament Settings to CURA 4.4

[Isegrimm]

Hi there ...

... first, this my entry-post in this board and i hope, i've chosen the right Thread.

I bought me a Geeetech A20M and tried my first steps. First of all, i'll print a "calibration Cube" and therefore i use "CURA 4.4".

Adding the a20M-profile in it was easy, i found it here in the community. But ...

... how can i add the Filament-Profile? I'm using the Geeetech-PLA-Filaments

PLA 1.75mm BLACK 700-001-0426
PLA 1.75mm NEW WHITE 700-001-11-45

Is there a Filament-profile like for the printer or do i have to create a custom profile ... but with which preferences?

Sincerely ...
Stefan

[William]

Hi, you can refer to this:

01.png (193.75 KiB) Viewed 10494 times

4%E78E1(P88O}8D4~6261PQ.png (187.97 KiB) Viewed 10494 times

[Isegrimm]

Hi William ...

... that was fast

THX for the Screenshots.

(Where do you buy the filament with 5.00€/500gr. ?