Installing Smartto

Post Reply
KinCatia
Posts: 16
Joined: Mon Jun 24, 2019 1:14 am

Installing Smartto

Post by KinCatia » Sun Jul 14, 2019 1:20 am

High I have an A30 and want to change some of the parameters so I downloaded smartto motor 1.2 for windows zip file. I'm using an old XP laptop, I ran the file and changed my path. I plugged the printer cable in and updated the drivers. I double click main.exe and it appears to run in a dos window but I see a few failure lines go by and it closes. I tried EasyPrint incase the port wasn't set correctly but that works. Running smartto the printer act as if it's initializing the same as it did with EasyPrint but I get no interface or anything other than the dos window.
Is there a guide or anything some one could point me to, for setting smartto up on XP?

User avatar
_kaktus_
Site Admin
Posts: 1237
Joined: Fri Dec 15, 2017 10:06 pm
Location: PL
Contact:

Re: Installing Smartto

Post by _kaktus_ » Sun Jul 14, 2019 12:14 pm

Hello.
:mrgreen:

This application is not properly supported by XP OS.
On the forum I help to use the rod, I don't give fish.
Geeetech Prusa I3 M201 Dual extruder Mixcolor 3D printer, bought 2017-12-19, already built, in the cognitive and improvement phase
Geeetech filament, ABS only
Geeetech 3D WiFi Module for 3D Printer, bought 2018-04-15, He got a new life, and still lies in a drawer.
Positively frenzied customer of Getech Technology.

KinCatia
Posts: 16
Joined: Mon Jun 24, 2019 1:14 am

Re: Installing Smartto

Post by KinCatia » Mon Jul 15, 2019 3:50 am

Thanks, I borrowed a mates win 10 laptop and it worked. I had to set x motor travel 335 and y to 340 to get it to move to the far edges of the bed. :D

Post Reply

Who is online

Users browsing this forum: No registered users and 3 guests