Easy Print 3D - Infill percentage not possible

Post Reply
bobmedia
Posts: 1
Joined: Wed Apr 03, 2019 3:30 pm

Easy Print 3D - Infill percentage not possible

Post by bobmedia » Wed Apr 03, 2019 3:35 pm

Hello, i am using Easy Print 3D and want to print with 100% (or any other percentage) infill, but can't find a setting in the Settings Paramters. Here i can find:

Infill Pattern (Line, Grid etc.)
Infill Overlap
Line Distance

There is a % behind Infill Pattern but i can't enter a number there because after pressing apply there is an error "Invalid Paramter".

User avatar
William
Site Admin
Posts: 4003
Joined: Tue Jun 07, 2016 9:38 am

Re: Easy Print 3D - Infill percentage not possible

Post by William » Fri Apr 26, 2019 3:39 pm

Hi, the Easy Print 3D is too old, I advise you to use Cura.
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

Post Reply

Who is online

Users browsing this forum: No registered users and 3 guests