Page 1 of 1

G2s Pro Firmware update via 3-in-1 control box blanks display.

Posted: Tue Mar 12, 2019 11:53 am
by isjohn
I apologise in advance if this issue has been addressed elsewhere.

I am attempting to updated the firmware on a newly assembled G2S Pro with a 3 in 1 control box to 1.0.04 using Easyprint 3D. The process run through fine but the display on the 3 in 1 is left blank. I have resolved the issue by reverting back to a modified (to support the 12864 display) 1.0.3 Marlin firmware but I now am seeking assistance with obtaining the current firmware image file for the G2S Pro / 3 in 1 control box combination . Is it available or has this combination been overlooked by the software developers?

Any assistance would be appreciated.

Re: G2s Pro Firmware update via 3-in-1 control box blanks display.

Posted: Fri Apr 26, 2019 5:52 pm
by William
Hi, the EasyPrinter 3D is too old, I advise to use Cura.