Neither the hotbed or extruder heat up

Post Reply
robotic-J
Posts: 2
Joined: Mon May 02, 2016 8:58 am

Neither the hotbed or extruder heat up

Post by robotic-J » Wed Jun 28, 2017 11:01 am

I have been using my Prusa 13 A pro, occasionally, for about one year, with no problems. Today, when I set up to print, both the hotbed and the extruder would not heat up. Any help will be greatly appreciated.

User avatar
William
Site Admin
Posts: 6331
Joined: Tue Jun 07, 2016 9:38 am

Re: Neither the hotbed or extruder heat up

Post by William » Wed Jun 28, 2017 11:21 am

You need first check whether the hot bed and extruder line connection is good, especially with the board connection.
If above of all is ok,please refer to the following link:
http://www.geeetech.com/forum/viewtopic ... 19&t=17039
-Keep your mind and try to test it. :)
-Everything will be fun!-Support all Getech printer.
-You can ask me the questions and I will kindly reply.
-Respect others is the best way you can get help!

robotic-J
Posts: 2
Joined: Mon May 02, 2016 8:58 am

Re: Neither the hotbed or extruder heat up

Post by robotic-J » Thu Jun 29, 2017 12:39 am

Thanks William! It was a loose connection. Printing nicely, as I am writing this.

Post Reply