Page 1 of 1

Hotend moves down into the finished print

Posted: Wed Mar 15, 2017 6:14 am
by Jaran
As they title says, my hotend moves down straight into the object as soon as it finishes. This does not happen every time, but I would say it happens 7/10 times. I am using Simplify3d and have added a g-code to move up 15mm after finishing the print, and in 3/10 prints this works as intended. The other prints it decides to go straight down into the print, or move towards home then go down into the print. Does anyone know how this is happening?

Re: Hotend moves down into the finished print

Posted: Sat May 20, 2017 3:53 am
by Soadyheid
I see that Simplify 3D is proprietary with a cost of about $150.00. If you bought it have you checked with them and their community? You've probably got some sort of support purchased within that cost.

Play Bonny!

Soadyheid.

Re: Hotend moves down into the finished print

Posted: Sun May 21, 2017 12:21 am
by Jaran
Yeah, turned out it was some wrong gcodes ^^