Hotend moves down into the finished print

Post Reply
Jaran
Posts: 16
Joined: Tue Feb 28, 2017 9:19 am

Hotend moves down into the finished print

Post by Jaran » Wed Mar 15, 2017 6:14 am

As they title says, my hotend moves down straight into the object as soon as it finishes. This does not happen every time, but I would say it happens 7/10 times. I am using Simplify3d and have added a g-code to move up 15mm after finishing the print, and in 3/10 prints this works as intended. The other prints it decides to go straight down into the print, or move towards home then go down into the print. Does anyone know how this is happening?

User avatar
Soadyheid
Posts: 44
Joined: Fri Apr 07, 2017 8:55 am

Re: Hotend moves down into the finished print

Post by Soadyheid » Sat May 20, 2017 3:53 am

I see that Simplify 3D is proprietary with a cost of about $150.00. If you bought it have you checked with them and their community? You've probably got some sort of support purchased within that cost.

Play Bonny!

Soadyheid.

Jaran
Posts: 16
Joined: Tue Feb 28, 2017 9:19 am

Re: Hotend moves down into the finished print

Post by Jaran » Sun May 21, 2017 12:21 am

Yeah, turned out it was some wrong gcodes ^^

Post Reply