Hello,
I bought geeetech pro C about 1.5 years ago and I moved from gt2560 to ramps 1.4
http://www.ebay.com/itm/3D-Printer-Cont ... OSwcUBYRUH~
can you please share with me the software for the printer for ramps 1.4 (not 1.3) for arduino mega?
thanks in advance
RAMPS 1.4 software for pro C
Re: RAMPS 1.4 software for pro C
Maybe you are looking for this?
viewtopic.php?f=20&t=17046
-
- Posts: 21
- Joined: Fri May 27, 2016 6:05 pm
Re: RAMPS 1.4 software for pro C
thanks!!
in the configuration.h written:
#define MOTHERBOARD BOARD_RAMPS_13_EEB
are you sure it would work on 1.4? becuase 13 as far as i know means ramps 1.3...
in the configuration.h written:
#define MOTHERBOARD BOARD_RAMPS_13_EEB
are you sure it would work on 1.4? becuase 13 as far as i know means ramps 1.3...
-
- Posts: 21
- Joined: Fri May 27, 2016 6:05 pm
Re: RAMPS 1.4 software for pro C
thanks!!bang wrote:Maybe you are looking for this? viewtopic.php?f=20&t=17046
in the configuration.h written:
#define MOTHERBOARD BOARD_RAMPS_13_EEB
are you sure it would work on 1.4? becuase 13 as far as i know means ramps 1.3...