RAMPS 1.4 software for pro C

Post Reply
ohad135123
Posts: 21
Joined: Fri May 27, 2016 6:05 pm

RAMPS 1.4 software for pro C

Post by ohad135123 » Tue Mar 14, 2017 6:06 pm

Hello,
I bought geeetech pro C about 1.5 years ago and I moved from gt2560 to ramps 1.4
http://www.ebay.com/itm/3D-Printer-Cont ... OSwcUBYRUH~

can you please share with me the software for the printer for ramps 1.4 (not 1.3) for arduino mega?
thanks in advance

bang
Posts: 402
Joined: Wed Dec 28, 2016 2:12 pm

Re: RAMPS 1.4 software for pro C

Post by bang » Wed Mar 15, 2017 1:44 pm

Maybe you are looking for this?
QQ截图20170315134341.jpg
QQ截图20170315134341.jpg (12.46 KiB) Viewed 4155 times
viewtopic.php?f=20&t=17046

ohad135123
Posts: 21
Joined: Fri May 27, 2016 6:05 pm

Re: RAMPS 1.4 software for pro C

Post by ohad135123 » Wed Mar 15, 2017 7:17 pm

thanks!!
in the configuration.h written:
#define MOTHERBOARD BOARD_RAMPS_13_EEB

are you sure it would work on 1.4? becuase 13 as far as i know means ramps 1.3...

ohad135123
Posts: 21
Joined: Fri May 27, 2016 6:05 pm

Re: RAMPS 1.4 software for pro C

Post by ohad135123 » Wed Mar 15, 2017 7:56 pm

bang wrote:Maybe you are looking for this?
QQ截图20170315134341.jpg
viewtopic.php?f=20&t=17046
thanks!!
in the configuration.h written:
#define MOTHERBOARD BOARD_RAMPS_13_EEB

are you sure it would work on 1.4? becuase 13 as far as i know means ramps 1.3...

Post Reply