Simplify3d Settings
Posted: Tue Nov 15, 2016 2:34 pm
Hi all
Having problems with Simplify3d, When I print from SD card the printer homes then goes straight to print without pre heating the nozzle and bed, here are the settings I got from Prusa's forum
;Sliced at: {day} {date} {time}
;Basic settings: Layer height: {layer_height} Walls: {wall_thickness} Fill: {fill_density}
;Print time: {print_time}
;Filament used: {filament_amount}m {filament_weight}g
;Filament cost: {filament_cost}
;M190 S{print_bed_temperature} ;Uncomment to add your own bed temperature line
;M109 S{print_temperature} ;Uncomment to add your own temperature line
G21 ;metric values
G90 ;absolute positioning
M82 ;set extruder to absolute mode
G28 X0 Y0 ;move X/Y to min endstops
G28 Z0 ;move Z to min endstops
M117 Auto Calibration... ;Put printing message on LCD screen
G29 ;auto bed level
G1 Z15.0 F{travel_speed} ;move the hotend up 15mm
G1 X0 Y0 Z0.4 F5000
G92 E0 ;zero the extruded length
G1 F200 E30 ;extrude 30mm of feed stock
G92 E0 ;zero the extruded length again
G1 X50 Y0 Z0.1 F2000 ;
G1 F{travel_speed} ;
M117 Printing... ;Put printing message on LCD screen
Don't have a clue on the G-code settings.
What should I alter and do I need to alter any settings in Simplify3d?
Having problems with Simplify3d, When I print from SD card the printer homes then goes straight to print without pre heating the nozzle and bed, here are the settings I got from Prusa's forum
;Sliced at: {day} {date} {time}
;Basic settings: Layer height: {layer_height} Walls: {wall_thickness} Fill: {fill_density}
;Print time: {print_time}
;Filament used: {filament_amount}m {filament_weight}g
;Filament cost: {filament_cost}
;M190 S{print_bed_temperature} ;Uncomment to add your own bed temperature line
;M109 S{print_temperature} ;Uncomment to add your own temperature line
G21 ;metric values
G90 ;absolute positioning
M82 ;set extruder to absolute mode
G28 X0 Y0 ;move X/Y to min endstops
G28 Z0 ;move Z to min endstops
M117 Auto Calibration... ;Put printing message on LCD screen
G29 ;auto bed level
G1 Z15.0 F{travel_speed} ;move the hotend up 15mm
G1 X0 Y0 Z0.4 F5000
G92 E0 ;zero the extruded length
G1 F200 E30 ;extrude 30mm of feed stock
G92 E0 ;zero the extruded length again
G1 X50 Y0 Z0.1 F2000 ;
G1 F{travel_speed} ;
M117 Printing... ;Put printing message on LCD screen
Don't have a clue on the G-code settings.
What should I alter and do I need to alter any settings in Simplify3d?